Config AutoDim

KeyCreator Detail Auto Dimension Configure

 

Use this function to configure the type of automatic dimension you intend to create, through the Auto Dimension Configuration dialog that appears when the function is selected. This dialog contains six pages; Mode and Selection, Vertical, Horizontal, Arcs, Circles and Table. The settings contained in each page are explained in the following segments below. Once you have configured the appropriate settings in this dialog, select OK to accept the settings.

 

To view information on an Auto Dimension dialog page, click on the appropriate link below:

Mode and Selection

Vertical and Horizontal

Arcs

Circles

Table

An unhandled error has occurred. Reload 🗙