Studs

Studs

Continuous thread and double ended studs use fields listed in the General Fastener section earlier in this chapter.  However, there are a few things that you should note in regards to the Stud database:

  •  For continuous thread studs, the LNG and THRD fields need to always be the same.  

  •  For double ended studs, the THRD value needs to be less than LNG divided by 2.

  •  The HEAD field is reserved for future use and should always be NONE.

Note that values that do not follow the above rules give unpredictable results.

An unhandled error has occurred. Reload 🗙