KeyCreator Drafting / Mechanical / HoleHloesDrilled HoleTo create a drilled hole, enter the information about the feature in this dialog box. Reamed HoleTo create a reamed hole, enter the information about the feature in this dialog box. Tapped HoleYou can create a tapped hole by selecting the Tap icon from the Features Menu. Counterbored HoleTo create a counterbored hole, enter the information about the feature in this dialog box. Countersunk HoleTo create a countersunk hole, enter the information about the feature in this dialog box. CounterdrilledTo create a counterdrilled hole, enter the information about the feature in this dialog box. Pipe TapTo create a Pipe Tap, enter the information about the feature in this dialog box. To create a Slot/Pocket feature, enter the information about the feature in the dialog box, which is shown below. FeaturesFeature Overview Feature SetupEach Feature dialog box contains a Setup tab that can be used to configure the feature. Using Mechanical CommandsUsing Mechanical Commands Feature CenterlinesEach Feature dialog box contains a Ctr Line tab that can be used to add and configure centerlines the feature. Global Attributes SetupMany KeyCreator functions use a common Attributes dialog box/tab. |